Busy [Busy] Pin 11 This signal is high when the printer is busy and low when it is able to accept more data. Remove the process unit from the printer and slide the charger knob back and forth to clean the charger wire. Prescribe commands technical reference manual – rev. There are quite a few printer problems which may be corrected by the user. Page 31 After reinserting the paper cassette, you should be able to print. Label paper must be manually fed. If some kind of printer problem should occur, check the following before concluding the printer is broken.

Uploader: Nisho
Date Added: 28 April 2009
File Size: 26.5 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 40623
Price: Free* [*Free Regsitration Required]

Download Center

Uneven paper weight can cause multiple feeds, print kyocera ecosys fs-1010, poor toner fusing, blurring, and other print kyocera ecosys fs-1010 problems. Label paper must be manually fed. SG – Signal Ground – Pin 7 All signals can transmit between the printer and the host computer to send each signal with a signal ground.

Windows XP, Vista, 7, 8, 10 Downloads: Remove the DIMM from its package.

ffs-1010 All rights are reserved. See Chapter Clean the charger wire. On most computers, permanent settings must be made with DIP switches. Page 71 Parallel Interface Table B.


They are indicated on the status printout. kyocera ecosys fs-1010

Page 7 Contents Printer Specifications Lock Lever 1 Gently remove the old toner container. This mode enables faster data transmission between the printer and the host computer.

The printer prints on the paper kyocera ecosys fs-1010 and type set in that particular paper source.

Kyocera FS-1010 Operation Manual

Normal Indicator Display When the printer is switched on for the first time after the toner container is installed, Adding toner also appears. Chapter 2 This chapter explains how to kyocera ecosys fs-1010 the toner container and how to clean parts such as the kyocera ecosys fs-1010 roller and charger wire. Insert the memory CF card into the card slot located on the rear of the printer. DIMM out of the socket.

Kyocera Ci Printer Kyocera. This section explains the following topics: Only network interface cards operating on DC 3.


This chapter explains how to handle printer problems that may occur, such as paper jams. When paper is manufactured, it is cut into sheets with the grain running parallel to the length long grain or parallel to kylcera width short grain. Subscription auto-renews at the end of the term Learn more. Chapter 4 Paper Selection This chapter explains the types of paper that can be used kyocera ecosys fs-1010 the printer.


Finally, it explains how eocsys use the kyocera ecosys fs-1010 in a multi-computer environment. Page 64 DIMM out of the socket. Cleaning Never stand the process unit on end.

Appendix C Printer Specifications, Chapter 1 Basic Operations, Glossary This chapter explains how to handle printer problems that may occur, such as paper jams. See Chapter Check the operator panel. Page 31 After reinserting the paper cassette, you should be able to print. Kyocera FS drivers are tiny programs that enable your Printer hardware to communicate with your operating system software.

If such a message appears, operation resumes when this key is pressed. Kyocera ecosys fs-1010 print the manual completely, please, kyocera ecosys fs-1010 it.

Insert the option network interface card into the option interface slot at the rear of the printer. Copying or kyocera ecosys fs-1010 reproduction of all or part of this manual, any copyrightable subject matter without the prior written consent of Kyocera Mita Corporation is prohibited. Replace with a new toner kit.